Roadlert support

Email support@roadlert.com and we’ll get back to you, usually within two working days. Tell us your iPhone model, iOS version and what happened.

Before you drive

Common fixes

It says the phone isn’t aimed at the road

Turn the phone sideways (landscape) with the rear camera facing forward, and tilt it until the road fills the lower half of the picture. The readiness pill at the top of the drive screen lists anything still to check.

Following-distance alerts seem too early or too late

Change Sensitivity (Low, Normal, High) in Settings. Calibration also improves over the first few minutes of traffic, so give it a drive or two.

Eyes-on-road alerts don’t work

They need an iPhone XS, XR or newer, a speed of 15 mph or more, and the front camera able to see your face. They pause behind dark sunglasses and in a very dark cabin.

No lane lines are drawn

Lane lines need visible paint and enough road in view. A very low dash mount may not see enough. When the low sun shines into the camera, lanes pause and the screen says so.

The phone gets hot

Keep it out of direct sun, remove thick cases, and point an air vent at it if you can. Roadlert lowers its frame rate when the phone is hot.

I can’t hear the alerts

Check the speaker button at the bottom left of the drive screen (voice on), the phone’s volume and Silent mode, and that the audio is going to the car if you’re connected by Bluetooth.

Requirements

iPhone with iOS 17 or later. Eyes-on-road alerts need an iPhone XS, XR or newer.

Reporting a safety concern

If Roadlert missed something it should have warned about, or warned about something that wasn’t there, please email us with the date, time and what happened. If an event clip was saved, you can attach it. Clips never leave your phone unless you share them.